Check the listing for details. Adjustable Chromoly Drag Racing Single Wheelie Bar- Unwelded. Condition: New. Listed at 1095.00 USD. Developed from years of use on our own cars the HRS wheelie bar is is a high quality solution for controlling the launch of your car. Designed to mount on any 3" axle at a 22" width. Our slider own spring combination and machined slider assembly will give you a smooth transition at the wheel to smooth the cars launch.All chromoly construction and ready for you to notch and weldIn house designed slider assembly that has been designed to work with our own spec high compression rate springCan be set up with 6'' travel or reduced to 4" travel in low clearance scenarios10 Ga CRS axle bracketsGrade 8 hardware though out with mechanical flex lock nuts to ensure long life and a quality appearance48" in length measured from axle center line to wheelAvailable in bare metal Wheel height should be set so the wheelie bar does not physically contact the bottom of the car if it bottoms out the slider travel. Typically placing the wheel 8" off the ground is a good place to start with the quick release pin in the lower hole (upper hole for transport).Disclaimer