Check the listing for details. LB05FP Replacement Spark Plug Cap for ATV's Motorcycles Snowmobiles (PAIR). Color: Black, Condition: New. Listed at 12.95 USD. (2) Spark Plug Caps Resistor Cover - 90 Degree - LB05FP New spark plug resistor cover replaces NGK's now discontinued LB05FP for the CB350 twin and most of Honda's other twin's from the 60's and 70's. This one has a 90 degree bend. For 14mm thread spark plugs without the terminal nut. Special rubber waterproof boot to seal out the elements. We recommend using non-resistor type spark plugs when using resistor caps on vintage Honda's.Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.For use with 7mm diameter plug wiresFits all Honda Twins from the 60's and 70's plus a lot of single cylinder 4 strokes and 2 strokesSold Individually Replaces NGK Part Number: 8030 Replaces Honda Part Number: 30700-098-153 Installation tips: Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug. Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case. Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight. When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover. Twist on the new cover about 3 full turns and give it a tug to make sure it's snug. Fits tons of bikes and many models used more than 1 type of cap. Check the part number and photo to see if it's what you need.