Check the listing for details. Ram 94-97 Map Light Double Gauge Pod Angled. Condition: New. Listed at 45.00 USD. Ram 94-97 Map Light Double Gauge Pod Angled This 3D printed part replaces the cubby or temperature readout in the map light to run two 52mm gauges. The pods fit a 52mm or 2 1/16 gauge. It will work on any second generation Ram pickup 94-97 1500,2500 or 3500. It will not work on any other year Ram pickup. The design screws into the factory mounting spots in the map light reusing the factory hardware and doesn't require any cutting or drilling. This is a raw 3D printed part and you will see small lines from being made. The part can be sanded and painted and you won't see any lines. This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim. Installation is simple and requires basic hand tools. Remove the map light with the two screws in the back towards the windshield. The maplight is also held in with two interior clips just pull down and it will come out. Install the design in the maplight by removing the cubby or temperature readout and reusing the stock hardware. Be carful when removing the screws! While testing my designs I broke some of the mounting points just by unscrewing them. The trick is to go slow when removing the screws and hold onto the plastic with some needle nose pliers. If you go too fast you will twist or break the plastic. The second gen trucks are notorious for brittle plastic. I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge, the design will need sanding or you have a gauge larger than 52mm. My gauge pod designs are meant to fit snug so you don't have any rattles or noises. Inexpensive gauges are either larger or smaller than 52mm. If your gauge is too loose add a layer of tape until it fits. Made out of ABS plastic the same material most automotive interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines. I make a few other designs for the 94-97 Ram if you don't like this one. If you have any questions just ask!