Check the listing for details. SCX 60s Muscle 6 Gauge Set, Stainless Bezels, 6964SS. Condition: New. Listed at 604.41 USD. SCX 60's Muscle 6-Gauge Set Why Buy From Us? We double check each gauge for correct operation before packing your order. This process includes putting signals to all gauges to verify correct operation. We verify no accessory items are missing (u-clamps, bulbs, senders etc) . We photo document your order to ensure completeness. Fast shipping via FEDEX or UPS (Signature Required). "No hassle" extended warranty. If you buy from us and have an issue with a gauge just send it back and we'll replace it, even it is more than 1 year later. Features: High quality gauges made in Orange County, CA USA.High-speed full sweep stepper motor gauges Programmable speedo with one-step easy calibration and 2 Trip metersFuel level gauge programmable for 0-90 ohm, 240-33 ohm, 73-10 ohm, 0-30 ohm and 20-150 ohm sending units. Green through-the-dial LED lighting for easy viewing at night 3D glowing pointer for easy visibility at night Why pay $800+ for a comparable set? Set includes: 3-3/8" Electric Programmable Speedometer, 0-160 MPH (0-240 KM per Hour) 3-3/8" Tachometer, 0-10,000 RPM 2-1/16" Volts, 8-18V 2-1/16" Oil Pressure, 0-100 PSI with sender 2-1/16" Water Temperature, 100-260F with sender 2-1/16" Programmable Fuel Level Empty-Full (5 different ranges) Through-Dial LED Lighting This set features through-the-dial LED lighting and glowing 3D pointer for a cool look and easy viewing at night. Made in the U.S.A. This item is made in California, USA. Please allow 1-2 days for your item to be made before it ships. Matching Vac/Boost, Trans Temp, Oil Temp & Fuel Pressure Gauges Matching Vac/Boost, Transmission Temperature, Oil Temperature, and Fuel Pressure gauges are available for this gauge set. Please contact us to order. Frequently Asked Questions Are sending units included? The oil pressure and water temp sending units are included. The volts gauge does not require a sender. A fuel level sender is not included. Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions: Pulse range generated proportional to the vehicle speed Signal with minimum 3V peak to peak signal - typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm) If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender. If you need a hall effect sender we can add a FORD or GM/Mopar hall effect sender to your order for a nominal charge. Contact us for details. The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer. The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box). TERMS & CONDITIONS Standard terms and conditions apply to this item. See our terms and conditions here: Terms & Conditions. Rev: 9/19/22