Check the listing for details. 2 PCS Dual-H-bridge 2 Channel DC Motor Driver Module Board DRV8833 1.5A 3V-10V. Condition: New. Listed at 9.95 USD. 2 Pieces Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor.The speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. Operating Voltage: 2.7-10.8VCurrent: 1.5A continuous (2A peak) per motor Motor outputs can be paralleled to deliver 3A continuous (4 A peak) to a single motorTiny package: 18mm x 16mmStandby control to save powerCW/CCW/short brake/stop motor control modeReverse-voltage protection circuitUnder-voltage lockout and protection against over-currentOver-temperature protectionFiltering capacitors on both lines PWM signals IN1, IN2 and IN3, IN4Motors connect to OUT1, OUT2 and OUT3, OUT4Jumper J2 (connected through EEP pin for mode control) - connect to enable device. Leave disconnected to enable sleep.ULT pin: Logic low when in fault condition like over-temperature, over current, etc.