Check the listing for details. 3D Scanner Targets - Geometric Target Markers (Half-Cubic) (10 pieces). Condition: New. Listed at 15.00 USD. Increase your visible marker-counts to decrease scan-lock instability and errors in marker-modes. Angled scanner-markers give flexible options that can allow near-horizontal scanning while on a very basic turntable setup.This is very difficult and often impossible with flat marker mats as they constantly lose tracking due to shallow angles, and sticking markers on parts obscures the geometry, which is obviously very problematic in it's own ways. I've personally tested my own designs on both Revoscan (Mini) and (Pop) scanners. The improvement I get over the included static plates is like night and day, being able to nestle small markers near to parts, that give more than a single marker-point and at new angles, that can be seen from over-top the part, is a very powerful tool for these types of structured-light scanners.-----------------------------------------Half Cuboid: Designed to give good visibility even when packed in closer to object being scanned. A note about markers with magnets: When using any sort of horizontal turn-table arrangement, I'd suggest against using magnets in the markers, as they will have a tendency to subtly suddenly push or pull on one another when intentionally packed in close proximity.----------------------------------------- I've designed these markers from scratch, have done tests on their material reflectivity vs intended scan targets, and have the utmost for good quality control of materials, part finish, and marker application to a clean surface. Pre-applied targets are 6mm diffusion dot type, surrounded by 10mm black. Other 10mm types may be applied.