Check the listing for details. 5 pcs Webasto W-bus module S-30 Clear/Erase Errors in 3 seconds. Condition: New. Listed at 360.00 USD. 5 pieces in the package For connoisseurs Heater that is also started by the Webasto Thermo Test (WTT) Diagnostic Program on the W-Bus option. Cleans up accumulated errors without needing interfacesdiagnostics or go to a service center.-press the button for 3 seconds and the errors are cleared.Led indication:-constant light -in standby-blinking light -w bus module started W-bus module S-30, for stovesWith it, you start your stove via w-bus and it becomes autonomous.Starts when 12v is supplied.Stops when 12v is interrupted.This is handy for connecting to:-remote module-sim controller-tsk key-weekly timer, etc W-bus S-30 has an outlet for a circulation pump.Additional outputs for water pump 12v (can be used at discretion)- after stopping the stove, the water pump continues to circulate for 120 seconds An increase in digital stoves may begin. TTC-MERCEDES, TOUAREG, WV T5, MAZDA 62008 , AUDI Q7, BMW TTV-WV TOURAN, PASSAT, GOLF V, CADDY, Land Rover 2006-2010). TTVEVO TTEVO 2017and other. The W-BUS module is an analog signal to digital converter based on W-Bus and is designed to work with stoves: Thermo Top VThermo Top EVOThermo Top C.Managed with: W-BUS V1.5, W-BUS v.3.1.(MAZDA 6 2008 ), W-BUS v.3.3.(VW TOURAN, VW CADDY, GOLF V, Land Rover 2006-2010) protocol,W-BUS v.4.1 EVO protocol, etc. The controller activates the stove in autonomous mode without the need for the car computer. Power supply: 12 v.Protection included in reverse polarity supply.W-Bus moduleLED indicator Dimensions: 50 x 30 mm.The set contains:W-bus module-1pcs Instruction:There is no + 12V applied to START and the RESET button is not pressed, then the LED should just light up. Error reset.If RESET is pressed for about 3 seconds, the LED flashes FAST during error clearing. And after cleaning the LED, it lights up without blinking. Enable WTT.It is necessary to supply constant voltage + 12V to START. The pump and stove will start. The LED should blink SLOWLY. If you remove the constant voltage + 12V to START, then the stove will stop and the pump will continue to work for 2 minutes. At the same time the LED should flash FAST.At the end of the work, the LED lights up continuously.