Check the listing for details. Auto/Car Lift Power Unit Switch up Button Raise Microswitch Motor Benwil Rotary. Condition: New. Listed at 23.12 USD. This is a heavy duty motor electrical micro switch made for MANY brands of Automotive lift power units.It controls the hydraulic motor and is the Up / Raise button for many lifts.It came in many OEM application on motors in Rotary lift, Forward Lift, Direct Lift, Hanmecson Lift, Challenger Lift, VBM Lift, Whip Lift, Western Lift Worth Lift & many more.It was used in motors built by SPX, Fenner Stone, Monarch, Barnes, Doer, Emerson, and used in other brand motors as well. Please see below for OEM part # reference.ALM A00242, Ammco 80282, Benwil 300282, 290037, Challenger Lift 1258-AA, Fenner 1288AA, Forward 991088, 991226, Manitowac C-723-20, Monarch 0352, MTE 69210023, Rotary Lift P461-2, FJ7108-2, SPX 1258-AA, SVI BH-7004-19, Western S707, Wheeltronics 6-0916 This is a heavy duty motor electrical micro switch made for MANY Rotary lift power units. It controls the hydraulic motor and is the Up / Raise button for many lifts. It was used in motors built by SPX, Fenner Stone, Monarch, Barnes, Doer, Emerson, and used in other brand motors as well that rotary used. Please see below for OEM part # reference. ALM A00242, Ammco 80282, Benwil 300282, 290037, Challenger Lift 1258-AA, Fenner 1288AA, Forward 991088, 991226, Manitowac C-723-20, Monarch 0352, MTE 69210023, Rotary Lift P461-2, FJ7108-2, SPX 1258-AA, SVI BH-7004-19, Western S707, Wheeltronics 6-0916 This Switch is rated for 25A and is usually found on 208-230VAC motors but can be used on 110V also. It has 3 screw terminals on the back/ bottom of the Micro switch where wires are connected (wires typically only connected to 2 out the 3 terminals). The terminals are usually marked “NO” “NC” “COMMON” or “COM” and the switch can be set up for normally open or normally closed operation.The front of the switch has a metal button/ plunger which is what actuates the switches operation. The plunger goes into a brass colored housing which has threads and nuts allowing the switch to be mounted to the face plate/ cover of the motor. Rotary Car Lift Electric Switch / Push Button for Hoist Most of the time when these switches fail, they either burn out at the terminal or can stick on and continually run the motor. Your old switch can be tested with a simple continuity test to identify if the switch is the cause of your problems. This switch can be wired Normally open or Normally closed depending on what terminals are used.