Check the listing for details. BANNER ENGINEERING ECONO-BEAM SE61RW1D W/30 Diffuse Mode Sensor SPST Solid-state. Condition: New. Listed at 129.99 USD. NEW BANNER ENGINEERING ECONO-BEAM SE61RW1D W/30 Diffuse Mode Sensor SPST Solid-state SE61RW1D W/30 - Banner Engineering ECONO-BEAM: Visible Red 650 nm Diffuse; Range: 200 mm; Input: 120V ac; Output: SPST Solid-state - DO; 9 m (30 ft) cableFeatures EZ-BEAM technology, with specially designed optics and electronics for reliable sensing without adjustmentsProvides reliable sensing in straightforward OEM applicationsAvailable in opposed, non-polarized retroreflective, diffuse and divergent diffuse, convergent, and glass or plastic fiber optic sensing modesAC supply voltage Supply Voltage and Current: 120V ac (±20%, 50-60Hz) · Supply Protection: Circuitry Protected against transient voltages· Output Configuration: Solid-state (FET). · SE61RW1 models: normally closed (dark operate) · Output Rating Maximum steady-state load capability 300 mA to 50°C ambient (122°F) Inrush capability: 1 amp for 20milliseconds (non repetitive) Off-state leakage current: less than 50 µA rms On-state voltage drop: ≤ 3 volts at 300 mA load, ≤ 2 volts at 15 mA load · Output Protection Circuitry Protected: against false pulse on power-up · Output Response Time: 10 milliseconds ON and 10milliseconds OFF Response time specification of load should be considered when important. (NOTE: 20 millisecond delay on power-up.) · Repeatability: 2.3 milliseconds; independent of signal strength· Indicators: Red indicator LED on top of unit is ON whenever the sensor sees its modulated light source · Construction: Reinforced thermoplastic polyester housing, totally encapsulated and acrylic lenses· Environmental Rating: Meets NEMA standards 1, 2,3, 3S, 4, 4X, 12, and 13; IEC IP66· Connections: PVC-jacketed 3-wire 9 m (30')cables· Operating Conditions Temperature: 0° to 50°C(32° to 122°F) Maximum relative humidity: 90% at 50°C (non-condensing)