Check the listing for details. Black Hammer Holder for Wall, Pegboard, or Ryobi Link Wall Rails Garage. Color: Black, Condition: New. Listed at 7.95 USD. Black Hammer Holder for Wall, Pegboard, or Ryobi Link Wall Rails This holds a hammer in the vertical position. It is designed to hold commonly-sized hammers and the narrowest point for the handle, near the top of the hammer, is 1.4" (37 mm). The left side has a curved slot for the neck/throat and the right side has a slightly higher straight bar for the claw. The back can be mounted in a variety of ways including screws to the wall, pegboard* with holes at 1" on center, and Ryobi Link Wall Rails. It includes 6 pegs: 3 curved and 3 straight. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place. A hammer is NOT included. Hammers shown in photos are for reference only. * Note that there are many different types of pegboard and some may not work. This was designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. It is 3D-printed in PLA plastic. It is 2.4" x 1.9" x 3.8" (61mm x 47mm x 96mm). https://acmcstudios.etsy.com?section_id=40486012