Check the listing for details. CLEAR-SEAL 100% Urethane Low Gloss Super Premium Sealer. Color: Clear, Condition: New. Listed at 202.40 USD. CLEAR-SEAL 100% Urethane Low Gloss Super Premium Sealer Clear-Seal 100% Urethane Low Gloss Super Premium Sealer Rainguard Clear-Seal™ 100% Urethane is an exceptionally tough, durable and breathable low gloss sealer. This product creates a hard low gloss film that is more UV resistant, stain resistant, and hot tire resistant than that of Clear-Seal™ acrylic urethane blended sealer. It provides a nice looking finish for concrete, stone, masonry, unglazed tile and wood surfaces. It is a water based, low VOC, single-component, self cross-linking clear urethane water based sealer. Clear-seal is available in both a Low gloss and High Gloss formula in 1 gallon and 5 gallon containers. For optimal results, add Urethane Quick Cure Performance Additive. Clear-Seal is designed to increase chemical resistance, impact resistance, chip resistance, added UV protection and better absorption of the Clear-Seal. Urethane Quick Cure Performance Additive mixes easily. Add 2 oz of Urethane Quick Cure per gallon of Clear-Seal™ 100% Urethane (select this option under the Performance Additive dropdown). Mix for 5-10 minutes. Adding Urethane Quick Cure gives the solution a 72-hour pot life. Extend pot life by adding more Urethane Quick Cure if needed. Where is Clear-seal Low Gloss used? Construction & Remodel Projects: Commercial floors subject to heavy foot traffic, walkways, protection of outdoor and indoor painted wall murals Homeowner projects: Driveways, garage floors, decks, patios, porches, walkways, fences Why Clear-Seal Low Gloss Sealer? Excellent Impact and wear resistant Resists hot tire pick-up for vehicular applications Performance Additive Available for Even Better Performance Excellent Chemical and Stain Resistance Resists UV rays - won't yellow Excellent adhesion UV protectant Anti-Slip Finish Available Interior/Exterior Protection for Concrete, Brick, Pavers, Stone, Unglazed Tile and Wood Specified by architects in CSI Division: 099123, 099723, 099313 TECHNICAL INFORMATION Color Clear Sheen/Gloss Level Low gloss Re-Coat Time When completely dry, 4-6 hours typical. Do not wait longer than 24 hours before applying a 2nd coat. If you do, sand surface with 100-150 grit sandpaper, remove debris, wipe with acetone just before application #Coats Recommended 1 – 2 coats depending on level of protection desired Back in-service time 24 hours to walk-on and 72 hours to drive-on Application method Spray, brush or roll (1/4″-3/8″ nap non-shed, water resistant) application. Sprayer requires use of heavy-duty acetone pump sprayer (ie; Chapin Xtreme) or pesticide sprayer (ie Hudson, Ortho) with low volume fan tip Where Can it be Used All Interior|Exterior architectural surfaces Apply to New Concrete 28 days Application Temperature 50F|10C up to 90F|32C Surface & Air temperature Base Water VOC Content