Check the listing for details. Famicom DIY AV Mod Kit for Composite Video. Condition: New. Listed at 47.99 USD. Famicom AV Mod Kit makes your Original Nintendo Family Computer to output AV Composite Video Removing the existing POWER & RF board and install this kit completes the job. No cutting of housing is required to install connector on the your precious Family Computer. Setup :1. Remove of phillips screws and bottom cover lifts right off2. Disconnect two controllers from the mother board3. Remove of all phillips screw from the mother board and power board. Remove two more phillips screws of power switch4. On the power board. Desolder the 7 wires that connect the mother board to the power board5. Place Mod kit and solder 7 wires on it6. Solder line of Power Switch7. Place 3D printing for gap filling and secure controllers, mother board and Mod Kit with phillips screws8. Close the bottom cover and screw it with phillips screws Features :Compatible with Original Nintendo Family Computer (1983)NOT FOR CHINESE CLONEAV Mod board, 3D printing for gap filling, AV cable (1.5 meter)5V/1A DC Adapter (EU/JP/US)Remove a lot of jailbarDO NOT USE ORIGINAL FAMICOM 10V PSUUSE ONLY 5V ADAPTER