Check the listing for details. FireFlo v3 3D Printed FPV Drone Frame by SirQuentin (3 PCS). Condition: New. Listed at 8.50 USD. Example Setups:Shock Absorbers:50g camera gimbal damper rubber anti-vibration shock absorber (http://r.ebay.com/Wfjzam)Motormounts:Motor holders for this frame can be found in the "CopterCustoms"-Group. (http://www.thingiverse.com/thing:1133331)Antenna Protection:Just use two cable ties and put them in the provided holes in the lower deck (see screenshots)Motors 7mm:micro-motor-warehouse.com: CL-0720-12, CL-0720-14Standard Hubsan x4 H107LFlight Control:(for a proper fit, you should remove the motor plugs and solder the motors directly to the board):NanoQx Board (MOSFETs need to be replaced when using 8.5mm motors)NanoQx FPV BoardMicroMWC (MOSFETs need to be replaced when using 8.5mm motors)SciSkyCam and vTx:NanoQx FPV CamSpektrum Ultra Micro FPV CAM SPMVA1100Selfmade like this: http://flitetest.com/articles/diy-micro-5-8ghz-fpv (but if you get this to fit, its more like a bumblebee then a firefly ;) ) Get the "Bumblebee Backpack" here: http://www.thingiverse.com/thing:1134205Energy:I recommend these for a flight duration of about 5-7min depending on your style and motors: 1s 3,7V 500mAh (http://r.ebay.com/a1v5I0)Velcro to strap it (10mm) WARNING: This frame uses 7mm motors For more information on this frame, go to thingiverse.com and type in FireFlo v3