Check the listing for details. Chaos Sorcerer - HQ, Pathfinder, D&D - Tabletop Gaming - 28/30/32mm Miniatures. Condition: New. Listed at 6.25 USD. The Chaos Sorcerer, a force to be avoided? The sorcerer is printed in resin, sculpted by Monstrous Encounters. Ideal for any tabletop RPG, such as Pathfinder, Dungeons, Dragons, and HeroQuest. The model is available in three sizes (listed after the Model name in the dropdown): 28mm - Ideal for use with the 80s version of Heroquest 30mm - Ideal for use with the re-release (2021) version of Heroquest, Gloom Haven etc 32mm - For the slightly more imposing size Bases are supplied separately and require attaching to the model. These are available in various sizes; if the size listed you would like is not listed, please contact us as we have a range of bases we can supply. If you have any special requirements (such as a different size or a mirrored version), please don't hesitate to contact us, and we will see what we can do. We print each miniature to order. Please allow up to 14 days for dispatch, we clean, cure and prepare our minis by hand whilst we endeavour to make sure each is as perfect as can be. However, little evidence of the supports used during printing might still be visible. Models may require some tidying up as you would with any miniature and can be done so carefully with a sharp craft knife or fine sandpaper. Please take care not to breathe in any resin dust; if it is slightly sticky after cleaning up the model, then place it in direct sunlight until solid. Ensure you wash your hands afterwards as uncured resin can irritate. Images shown are for illustrative purposes only and represent the unpainted model, typically in grey resin. Though the resin is pretty strong and resilient, it is not as strong as plastic miniatures. They may break from excessive force, such as being dropped. Please be aware that resin constantly cures when in contact with UV (such as sunlight); this can cause the miniature to become brittle over time. To protect it, you should prime, paint or coat it in a UV-blocking lacquer or varnish. We are a licensed reseller for Monstrous Encounters. You can find out more about their models via their Patreon: https://www.patreon.com/monstrousencounters/posts, or store on MyMiniFactory: https://www.myminifactory.com/users/Monstrous%20Encounters. If you would like a Monstrous Encounters model printed and we have not listed it, please contact us to see what we can arrange.