Check the listing for details. MACTAC self adhesive vinyl Matte White 54"x150. Condition: New. Listed at 239.00 USD. Product DescriptionPV328P is a 3.2-mil matte white, soft-calendared PVC film designed for UV and solvent-based ink jet printing. The product is coated on one side with a clear permanent, acrylic pressure sensitive adhesive and supplied with a 78# Clay Coated Kraft liner. PV328P is designed for general purpose indoor and short-term outdoor advertising and promotion on flat or slightly curved surfaces.SPECIFICATIONSAdhesive ColorClearApplication SurfacesCurvedFlatApplicationsFlat SurfacesPOP DisplayFilm TypeCalenderedPVCPrint CompatibilityEco-SolventLatexScreenprint UVSolventUVRemovabilityPermanentRecommendationsAlways test your combination of IMAGin products, inks and laminating films prior to commercial use. 1) Printing Conditions: Print in conditioned pressroom at ±73°F (23°C) and 50% RH. Ink saturation should not exceed 270%. 2) Drying Requirements: Solvent, Eco-solvent and Mild-solvent inkjet prints require 24 - 48 hr. drying time - open to the air. Inks do not dry when printed media is rolled up. The prints must be dry prior to lamination. 3) Laminating Conditions: If the printed graphic is likely to be exposed to corrosive liquids, smoke, fumes and highly polluted areas or there is a likelihood of scratching it is highly recommended you laminate with PERMACOLOR ColorGard LUV series (intermediate) or PromoGard (economical) overlaminating films. 4) Transportation Conditions: To allow for easy transportation, IMAGin series can be rolled up, with the image out, with a minimum diameter of 6 inches (15cm). When the image is not protected by an overlaminate, make sure the print is completely dry and protected in a plastic bag. During transportation or storage, avoid exposing them to extreme temperature and humidity changes.