Check the listing for details. Winchester 94 Top-Eject Pre-64 WR Weaver 1" Scope Side Mount No-Drill No-Tap. Condition: New other (see details). Listed at 144.99 USD. This Buy-It-Now is for a Very Hard To Find New Old Stock Still Unused Pre-64 Winchester Side Mount with No Drilling & No Tapping Required fits in Factory Holes on Side of Receiver Replaces the Lever Pin Screw & the Receiver Sight Holes. This is A Complete W.R. Weaver Side Scope Mount with Detachable Ring Mount For Scopes with a 1" Correct Mounting Screws For A Model-94 Pre-64 Made Before 1964 Lever-Action Top-Eject Side Scope Mount That Includes A Now Discontinued Pre-64 Side Mount Base & Mounting Screws No-Drill & No-Tap Side-Mount Base and a Long Detachable Side Ring Mount for a Scope with a 1" Main Tube. This Model 94 Pre-64 Mount Only fits the """ WINCHESTER Pre-64 MODEL-94 TOP-EJECT LEVER-ACTION ONLY """ and Comes With Weaver Quick-Detachable Side-Ring Mount Scope Mount for Scopes with 1" Main Scope Tube & Comes Complete with Correct Pre-64 Model 94 Quick-Convertible Base, Quick-Convertible 1" Rings & Correct Mounting Screws including the Very Hard to Find Smaller Lever Pin Screw for Mounting the Base. You Can Remove your Scope with Rings from Side Base by Simply Turning the 2 Large Thumb Screws on Side of Mount and will return to the same point of impact Removed. Everything you Need to Mount Your Scope on your Winchester 94 Pre-64 Lever-Action Rifle and is Unused Condition and still Looks New with No Scratches and No Wear. "" Make Sure your Winchester 94 pre-64 Was Factory Drilled And Tapped there was a few Pre-64 Model 94 Winchester's that wasn't drilled and tapped for the Receiver Peep Sight This Mount Replaces the Lever Pin Screw and Receiver Sight Screws in your 94 The Center to Center of Mounting Hole Pattern is From Center of Lever Pin Screw to Center of Closest Mounting Hole Center Is 2.300" & is 2.700" from Center of Lever Pin Screw to Rear Receiver Sight Center of Mounting Hole, And Receiver Sight Center to Center Mounting Hole Pattern is 0.400". Make Sure that this is the Mount you Need before Purchasing. I will Not Cancel Auctions after Winning Bid or Cancel a Buy-It-Now Make sure you want this Before Purchasing It. This Mount is Still Unused with No Scratches, No Marks & No Finish Wear. >>"" THIS MOUNT WILL NOT FIT A WINCHESTER 94 TOP EJECT LEVER ACTION MADE AFTER 1964 AND WILL NOT FIT A WINCHESTER 94 375 BIG BORE AND WILL NOT FIT A WINCHESTER Model 94AE ANGLE EJECT >>""" THIS ONLY FITS WINCHESTER MODEL 94 PRE-64 MADE BEFORE 1964.. Buyer Pays $8.00 Shipping in US & Will Ship Internationally for $30.00, Thank you, Terry